Polyfoam I-50 (W/B) System
Polyfoam I-50 (W/B) System
Two component, polyurethane injection foam system (water blown)
Properties
- Injection/pouring grade
- CFC & HCFC free
- Zero ODP
Description
Polyfoam I-50(W/B) is a two-component, Injection grade polyurethane foam that creates a seamless, monolithic barrier against water vapor and air. Polyfoam I-50(W/B) is water -blown & CFC / HCFC free, polymeric M.D.I based system for producing rigid urethane foam with a nominal core density of 50 kg/m3 by injection process. Grades, adjusted in reactivity, are available for both cold and hot condition.
TDS For Polyfoam I-50(W/B)
- Step by Step
Mix ratio
1 polyol :1.3 MDI by weight.
Typical reaction rate and density (laboratory, cup mix) (both components at 20°C & 100gm/mix)
cream time: 35 – 45 sec.
gel free time: 170 – 180 sec.
free rise density : 35 – 45kg/m3
Reactivity and density may vary depend on ambient temperature and grade.
Storage and Handling
Store at room temperature in sealed drums. Moisture will react with this component to produce a surface skin of polymerized material. Protect from moisture and moisture vapour. Close all drums after use. Maximum permissible storage time is 6 months. The ideal storage temperature is between +20ºC and +25ºC. MDI may undergo partial crystallization at temperature below 0ºC. The product can, however, be brought back into the liquid state by placing the container in a heating cabinet and Carefully warming the entire contents for a short time to a maximum of 70ºC. Polyol might store at room temperature (below 25°C.) in sealed drums. Close all drums after use to prevent absorption of moisture. Safety goggles, impermeable protective gloves and overalls should always be worn when handling this product. Contaminated clothing should be removed immediately to prevent further skin contact.
