Polypur TC 10
Polypur TC 10
Single component polyurethane car park coating
Properties
- Highly durable
- Excellent abrasion resistance
- Good chemical resistance
- Can be applied on many different substrates and on cured epoxy systems
- Excellent surface finish with different colors
- Easy to apply
Description
Polypur TC 10 is a single component high quality polyurethane car park deck coating system. The coating provides a seamless, abrasion resistant floor coating system for internal covered areas.
TDS For Polypur TC 10
- Step by Step
Surface preparation
The surface should be dry, free of any cement laitance, oil and grease, curing compound and any other contaminants, which may affect the bonding. Light mechanical scabbling, grit/captive blasting or grinding is recommended for cleaning the surface of such contaminants. New concrete surfaces should be 28 days old and the moisture content on the surface must be less than 5%. Refurbishment of existing or old floors must be done with a suitable repair mortar, in order to ensure that the bond between the old substrate and the new flooring system is very good. Surface irregularities and blow holes shall be repaired with Polypoxy BF* (Epoxy resin based blow hole filler and skimming mortar) or Ceresit RS 88* (cementitious repair mortar). Alternatively an epoxy resin based scratch coat can be used when repairing larger areas (> 0.5m2). The surface should be vacuumed after carrying out the necessary cleaning for removing the dust debris left over after the cleaning process.
Priming
Prime the prepared surface with Polyprime PU* @ 4-5m2/L. The coating is applied when the primer is dry. However, in all circumstances, the coating shall be applied within 24 hours of application of the primer. If the primer surface is left open for more than 24 hours, then a fresh coat of primer has to be re-applied. Broadcast Aggregate No. 3 on the primer whilst it is still wet @0.3 kg/m2. On ramp and turning areas, the aggregate shall be broadcasted @1.2-1.5 kg/m2. After the primer dries off, brush away or vacuum out the excess aggregates.
Top coat
Polypur TC 10 shall be applied as the abrasion resistant top coat. Mix the pail thoroughly with a suitable paddle mixer fitted to a slow speed drill (300-400 rpm) for a couple of minutes prior to application to remove any sediment. Apply the coating with a roller immediately after mixing @5 m2/L/coat to get a dry film thickness of 150 microns. If required apply a second coat at the same coverage rate and only after the first coat has dried off completely (24 hours). The coating will achieve its full mechanical properties after 7 days of cure, after which the floor can be subjected to heavy traffic.
