Hot

Polypoxy BF

Polypoxy BF

Epoxy repair putty and blow hole filler

Properties

  • Thixotropic. Can be applied on vertical surfaces
  • Good resistance to acids, alkalis, hydrocarbon fuels, oil and grease, solvents and sea water
  • High strength
  • Can be trowelled to a smooth finish
  • Creamy consistency, easy to use
  • Non toxic. Can be used in potable water applications

Description

Polypoxy BF is a two component, solvent free, epoxy resin based repair putty and mortar for concrete surfaces. The epoxy putty consists of graded fillers and non sagging agents which makes it ideal for application on vertical surfaces. Polypoxy BF is designed for filling of blow holes, cracks and minor imperfections on concrete surfaces.

TDS For Polypoxy BF

Surface preparation

Clean the concrete surface of all loose particles, laitance, dust, oil, grease, paint etc. Grit/captive blasting and mechanical grinding of the concrete floor is recommended for removing all surface contaminants.

Mixing

Polypoxy BF Part A and Part B shall be mixed thoroughly using a proprietary paddle mixer fitted to a slow speed drill till a uniform color and consistency is achieved. It is recommended to mix an entire kit at a time. However, for small repairs, part mixing can be done provided both the parts are accurately measured by weight.

Application

Application can be carried out by a steel trowel or putty knife or scraper. Press firmly the mixed mortar into the area to be filled to ensure proper adhesion and full contact. The epoxy putty shall be applied at a maximum thickness of 5mm in one layer.  Additional layers should be applied after the applied mortar achieves its initial cure.The area repaired with Polypoxy BF can be over-coated with any epoxy or polyurethane coating after it achieves its initial cure.